Visonic POWERMASTER-10 - INSTALLER GUIDE Guida Utente Pagina 12
- Pagina / 62
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
OPERATING THE POWERMASTER SYSTEM
D-303223 PowerMaster-10/30 G2 User's Guide 11
Note: When forced arming is carried out, the buzzer “protests” by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can silence this signal by pressing the arming button again.
If forced arming is enabled and you wish to arm the system when NOT READY is displayed, proceed as shown:
PRESS
RESULTING DISPLAY
ENTER CODE _ _ _ _
[Enter code]
Code
ARMING AWAY
PLEASE EXIT NOW
(to mute the buzzer)
Vacate the premises
(Exit delay)
AWAY
ARM indicator lights during the armed state.
Remember: Forced arming compromises security!!
Forced arming “HOME” is performed in a similar manner, as follows:
PRESS
RESULTING DISPLAY
ENTER CODE _ _ _ _
[Enter code]
Code
ARMING HOME
PLEASE EXIT NOW
(to mute the buzzer)
Go to interior zone
(Exit delay)
HOME HH:MM
ARM indicator flashes during the armed state.
Arming in the Latchkey Mode
This mode, if enabled by the installer, is useful for a parent at work who wants to be sure that his children have
returned from school and have disarmed the system. A special “latchkey” message will be sent out when the
system is disarmed by a “latchkey user”.
Latchkey users are holders of user codes or users of keyfob transmitters 5 through 8 (PowerMaster-10 G2) /
user codes 23-32 (PowerMaster-30 G2). The latchkey message is considered an alert and not an alarm, and is
therefore sent to the private telephones programmed by the user as targets for alert messages.
Latchkey arming is possible only when you arm “AWAY”. To arm in the Latchkey mode, proceed as follows:
PRESS
RESULTING DISPLAY
ARMING AWAY
ARMING LATCHKEY
(Within 2 seconds)
(alternating)
PLEASE EXIT NOW
Vacate the premises
(Exit delay)
AWAY
Note: Latchkey must be enabled by your installer.
ARM indicator lights during the armed state.
Initiating Alarms
Following are various methods that may be used for initiating alarms.
Initiating Panic Alarm
You can generate a panic alarm manually in the disarmed and armed states. The sequence will be as shown:
- USER GUIDE 1
- User's Guide 2
- PowerMaster-10/30 G2 2
- INTRODUCTION 4
- Basic Arming and Disarming 10
- Initiating Alarms 12
- SPEECH AND SOUND CONTROL 14
- ELECTRICAL APPLIANCE CONTROL 16
- Troubles 17
- General Indications 18
- MENUS AND FUNCTIONS 19
- (- - - - - - ......) 40
- Remote Control by SMS 42
- TESTING THE SYSTEM 45
- MAINTENANCE 47
- APPENDICES 49
Prodotti e manuali riguardandi Sistemi di controllo di accesso Visonic POWERMASTER-10 - INSTALLER GUIDE
(86 pagine)Panasonic HCVX980EB Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Kamerarekorder Panasonic HCVX980EB.
Wir stellen 1 PDF-Handbücher Panasonic HCVX980EB zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Commenti su questo manuale